Parkside PT360 Uživatelský manuál stáhnout pdf (Strana 39)

Igniting the flame

Continuous flame

Regulating the flame

1. Push the flame regulator (5) to position 4

2. Periodic operation

• Keep the safety switch (8) pressed and draw the ignition switch (7) to ignite the flame.

• Release the ignition switch to extinguish the flame.

3. Continuous operation

• Keep the safety switch (8) pressed and draw the ignition switch (7) to ignite the flame.

• Slide the continuous operation switch (4) to the in position CONT to lock the ignition

switch in the drawn position.

• Slide the continuous flame switch into the OFF position to extinguish the flame.

An irregular flame can be generated or gas can escape in fluid form If the gas soldering iron

is cold or has just been refilled. This is normal and does not indicate a fault. The flame will

stabilise once the device warms up (approx. 1-2 minutes).

Igniting and extinguishing the ﬂame

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Žádné komentáře

Parkside PT360 Uživatelský manuál Strana 39